How to install injection molding machine at customer side;
1.The installation area must have certain anti-pressure strength. If it installs on concrete, the groundsill depth is determined by ground quality, but the depth must over 250mm.
2.In order to maintenance and manage well, there must have enough space around the machine.
3.Lathe bed of machine and haul rod should be adjusted according to water level both from portrait and landscape orientation, tolerance 0.25mm. After using one week, it should be re-checked.
4.Use professional anti oscillation plate to fix machine, of which should be balanced pressured, thus the screw will not loose.
5.Connect electrical source, the incoming line of power in this machine applies the three-phase four-wire schematic with 380V electric pressure and 50HZ.